How to draw a belt

Learn how to draw a belt step-by-step tutorial. Fashion accessories like proper bags, shoes, belts, and jewelry can make or break your sketch. Understanding how to draw accessories will open up your designs and make them look even more attractive. Have fun with this tutorial!

47/10

5 min

drawing paper
pencil
eraser
colored pencils

Step 1: Set the guidelines

Decide where you want to place the belt and how wide it is going to be. Mark it with two parallel lines, allowing you to go out of the outlines of the fashion figure a little bit.

Step 2: Make it wrap around

To gain the sensations of a realistic belt that wraps properly around the body, curve the lines slightly according to the volume of the body underneath.

Depending on the perspective sometimes you will have to curve the lines in other directions. The point is that you shouldn’t leave them absolutely straight, but adjust it thinking of the volume underneath.

Notice that at the sides the belt goes outside of the model’s outline. This is because the accessory is put over the dress and this way you will make the sketch look more realistic and believable.

Step 3: The buckle

Draw the buckle. It could be any form, but I picked the classic square one for this example. The buckle should be just a hair bigger than the width of the belt.

Step 4: Overlapping

Erase the part of the buckle that is shown in the illustration and draw the overlapping piece of the belt. The little arrow shows how you should represent that the overlapping piece is placed over the belt itself.

See also

CLOTHESTutorials

How to draw a wrap dress

Step 5: Drawing the belt holes

Draw some belt holes before and after the buckle. Try not to go too far with them- draw only as much as you need and try to keep the space between each of them equal.
Make sure you have one of the holes drawn very close to the buckle. Add the tongue that goes over the buckle.

Step 6: Hold it!

Most of the belts have a belt loop that holds the overlapping piece not to fall down. You can draw that too. Make sure it wraps around the belt (Step 1 and Step 2).

Step 7: A finished look

Finally, add some stitching and if your design requires- draw loops to hold the belt.

This is the very base of drawing belts. Having this in mind now you can go crazy with your designs and make amazing collections!

Happy drawing!